FlexDSL ORION 3 - NETDEFAULT> Command

User Manual LTU Orion 3
134
CO_06_FMM>STATUS RADIUS
--------------------------------------------------------------------------------
Status : Server 1 Server 2
--------------------------------------------------------------------------------
Status : Not connected Connected
Server IP : 192.168.1.252 192.168.1.254
Server port : 1812 1812
Server key : entered entered
Retries : 2
Timeout,seconds : 2
--------------------------------------------------------------------------------
CO_06_FMM>
Parameter
Description
Status
Status of 1-st and 2-nd RADIUS Server
Server IP
IP address of 1-st and 2-nd RADIUS Server
Server port
Port, a server is listening on
Server key
Shows if shared secret has been entered or not
The <STATUS RADIUS [N/R/S/B]> command displays one of four RADIUS Server Status: New,
Running, Startup, or Backup, depending on the parameter.
4.6.5.119 <NETDEFAULT> Command
The <NETDEFAULT> command sets the following configuration The MAC address of the
modems takes the manufacturer value. The default IP address, sub-network masks and gateway
are not changed.
CP_01_NET>NETCONFIG
--------------------------------------------------------------------------------
Running Network Configuration
--------------------------------------------------------------------------------
Ethernet settings : LAN1 LAN2 LAN3 LAN4 LAN5 WAN1 WAN2 WAN3 WAN4 INT
Access/Trunk : ACC ACC ACC ACC ACC Trunk Trunk Trunk Trunk ACC
Port-based VLAN : [A] [A] [A] [A] [A] [A] [A] [A] [A] [A]
VLAN : 1 1 1 1 1 1
QoS : 2 2 2 2 2 2
VLAN1 VID=1 : + + + +
VLAN2 VID=2 : + + + +
VLAN3 VID=3 : + + + +
VLAN4 VID=4 : + + + +
VLAN5 VID=5 : + + + +
VLAN6 VID=6 : + + + +
VLAN7 VID=7 : + + + +
VLAN8 VID=8 : + + + +
OTHER VLANS : + + + +
Speed : AUTO AUTO AUTO AUTO AUTO
System settings :
MAC address : 00:0f:d9:00:00:00
IP address : 192.168.0.254
Subnet mask : 255.255.255.0
Default gateway : 192.168.0.254
--------------------------------------------------------------------------------
CP_01_NET>