FlexDSL ORION 3 - COSCONFIG [N;R;S;B]> Command

User Manual LTU Orion 3
110
Services
List of running management servers
Syslog servers
First and Second Syslog server IP address
SNTP servers
First and Second SNTP server IP address
TZ
Time Zone settings
Summer Time
Summer Time change settings
Winter Time
Winter Time change settings
Radius servers
IP address and port used for first and second RADIUS servers
Radius secret
Shows if shared secret has been entered or not
The NETCONFIG command always displays the running configuration. If the new configuration
differs from the running one, the NETCONFIG command displays the running configuration and
a warning:
--------------------------------------------------------------------------------
Warning: New network configuration differs from running network configuration!
To view new network configuration, type 'NETCONFIG N'
To view running network configuration, type 'NETCONFIG R'
To apply changes in configuration, type 'APPLY VLAN' or 'APPLY ALL'.
Do not forget to 'CONFIRM' a good working configuration.
CP_NET>
The <NETCONFIG [N/R/S/B]> command displays one of four configurations: New, Running,
Startup, or Backup, depending on the parameter.
After successful execution of a command that changes any parameter showed by NETCONFIG,
the new configuration is shown. The warning message explaining that the new configuration
differs from the running configuration is displayed as well .
4.6.5.53 <COSCONFIG [N/R/S/B]> Command
Without parameters the <COSCONFIG> command displays the running CoS configuration:
CO_NET>COSCONFIG
--------------------------------------------------------------------------------
Running QoS Configuration
--------------------------------------------------------------------------------
QoS to CoS mapping Per-VLAN CoS override
--------------------- ---------------------
QoS : 0 1 2 3 4 5 6 7 VLAN: 1 2 3 4 5 6 7 8
CoS : 3 3 3 3 3 3 3 3 CoS : - - - - - - - -
---------------Rate limit--------------------
Egress : WAN1 WAN2 WAN3 WAN4
CoS 0 : OFF OFF OFF OFF
CoS 1 : OFF OFF OFF OFF
CoS 2 : OFF OFF OFF OFF
CoS 3 : OFF OFF OFF OFF
---------------------------------------------
Ingress : LAN1 LAN2
Per port: OFF OFF
Total : OFF
--------------------------------------------------------------------------------
CO_NET>
It shows the QoS-to-CoS and VLAN-to-CoS mapping. CoS (Class of Service) as well as QoS
(Quality of Service) have to be configured for a correct behaviour!
The rate limits for any interface is showed too.
The <COSCONFIG [N/R/S/B]> command displays one of four CoS configurations: New, Running,
Startup, or Backup, depending on the parameter.