User Manual LTU Orion 3
98
To configure two reserve groups type the command as follows. Note that groups should not use
same channels.
The parameter NONE deactivates reservation.
4.6.5.20 <G704 ON/OFF [N]> Command
This command activates/deactivates the ITU-T G.704 framed mode for the Е1 interface with
number N. The <G704 ON 1> activates the ITU-T G.704 framed mode. The <G704 OFF 1>
deactivates the ITU-T G.704 framed mode, i.e., the devices starts operating in the so-called
transparent mode.
4.6.5.21 <CRC4 ON/OFF [N]> Command
This command activates/deactivates the CRC4 mode for the E1 channels, where N is the number
of the E1 channel.
4.6.5.22
<
A
ISGEN ON
/
OFF [N]>, <A
ISDET ON/OFF [N
]> Commands
The <AISGEN ON/OFF [N]> command activates/deactivates the AIS Generation mode for the E1
interface, where N is the number of the E1 interface.
The <AISDET ON/OFF [N]> command activates/deactivates the AIS Detection mode for the E1
interface, where N is the number of the E1 interface.
CO_CM>AISGEN ON 1
CO_CM>AISDET ON 1
4.6.5.23 <DSLTS list/NONE [N=1..4]> Command
This command sets transmitted/received time slots of the E1 channel with number N to be
transmitted over the SHDSL interface. The list consist of numbers of separate time slots or their
ranges, separated by comma. For example: 1,5,14-19. The empty list is set by typing NONE.
Spaces in the list are not allowed. Use the “minus” sign or two dots “..” to set the range.
CO_CM>DSLTS 0-31 1
CO_CM>DSLTS 0-12,16 1
CO_CM>DSLTS 1..31 1
4.6.5.24 <WANTS [list] [N=1..4]> Command (Ethernet over E1)
This command sets the list of E1 time slots to be transmitted over the WAN interface (Ethernet).
N is the number of the E1 interface.
CO_CM>WANTS 0-31 1
CO_CM>WANTS 12-18,19 1
CO_CM>WANTS 0-21,24 1
CO_CM>WANTS 1..21 1
4.6.5.25 <E1CLOCK [DSL/RX/EXT/INT] [N]> Command
This command sets the E1 output clock source for the WANTS mode.
Examples:
E1CLOCK DSL: The Rx clock of the DSL channel connected to this E1 interface
To Next Page
Loading...
