User Manual LTU Orion 3
79
4.6.4.16 <STARTAL [N]> Command
This command starts/stops (toggles) the analogue loop back at the SHDSL line interface on the
device with the number N. For single-channel devices this command is entered without the
parameter N.
CO_09_FMM>STARTAL 1
Analog loopback started
CO_09_FMM>STARTAL 1
Analog loopback stopped
CO_09_FMM>
This command is used in the Master mode. Detach the cable from the SHDSL connector
before starting the analogue loop back.
4.6.4.17 <RESTART [N=1..4]> Command
This command restarts the corresponding SHDSL channel. First it causes the loss of sync
between modems which later will be restored. For single-channel devices the command is used
without any additional parameters.
RR_FMM>RESTART 1
Restarting channel 1
RR_FMM>
4.6.4.18 <RESET> Command
The <RESET> command restarts the device.
4.6.4.19 <CONFIRM> Command
This command confirms the running configuration and writes it to the startup configuration. As a
result, after confirmation of the configuration variables changes in all groups, they will be written
from the running configuration into the startup configuration.
CO_FMM>CONFIRM
Current running configuration is confirmed and written to
startup configuration in EEPROM
4.6.4.20 <BACKUP> Command
This command is used to create a backup of the running configuration of the device in the
EEPROM. As a result, the running configuration is written to the backup configuration.
CO_FMM>BACKUP
Current running configuration is written to
backup configuration in EEPROM
CO_FMM>
4.6.4.21 <RESTORE> Command
This command restores the startup configuration from the backup configuration, which was stored
in the EEPROM. The modem should be restarted that restored values become valid.
CO_FMM>RESTORE
Restored startup configuration from backup configuration.
Reset modem for all changes to take effect
CO_FMM>
To Next Page
Loading...
