4.6.5.99 <SNMP [RO|RW] PRIV [MODE]> Command
This command set SNMPv3 user encryption type for RO or RW user. The following encryption
types are supported: DES,AES,NONE.
<SNMP RO PRIV DES>. This command set DES encryption type for SNMP user with Read-Only
access rights.
<SNMP RW PRIV AES>. This command set AES encryption type for SNMP user with Read-Write
access rights.
<SNMP RO PRIV NONE>. This command disables encryption for SNMP user with Read-Only
access rights.
4.6.5.100 <SYSLOG [1/2] [IP/OFF]> Command
There is a build-in system Log (SYSLOG) client according to Syslog protocol (RFC-3164). It sends
every message in a single UDP packet to the Syslog server. Message includes:
• Alarm status
• User login
• User actions
It is possible to add up to 2 Syslog severs. The SYSLOG command is used for that purpose.
SYSLOG [1/2] x.x.x.x - set 1st or 2nd IP address in x.x.x.x format.
SYSLOG [1/2] OFF - remove 1st or 2nd IP address.
4.6.5.101 <LLDP [ON/OFF]> Command
The <LLDP [ON/OFF]> command enables or disables LLDP messages exchange with all peers
through all interfaces. It is global setting.
CX_06_NET>LLDP ON
--------------------------------------------------------------------------------
LLDP : Enabled
--------------------------------------------------------------------------------
Retransmission Interval : 30
Transmission Multiplier : 4
Reinitialize Delay : 2
Transmission Delay : 2
Notification Interval : 5
MED Fast Start Counter : 3
LLDPU Transmission : Enabled
LLDPU Reception : Enabled
LLDP INT VLAN : Disabled
--------------------------------------------------------------------------------
CX_06_NET>
To Next Page
Loading...
