FlexDSL ORION 3 - ENCODE [ON;OFF] [N]> Command

User Manual LTU Orion 3
90
4.6.5.4 <ENCODE [ON/OFF] [N]> Command
This command activates or deactivates link-layer encryption on selected WAN channel [N]:
CO_01_CM>ENCODE ON 1
--------------------------------------------------------------------------------
Encoding : WAN1 WAN2 WAN3 WAN4
--------------------------------------------------------------------------------
Destination : DSL1 DSL2 DSL3 DSL4
Key : set set set set
Enabled : yes no no no
--------------------------------------------------------------------------------
Warning: New Encoding configuration is shown, because it differs from running.
To view new encoding configuration, type 'ENCODE N'.
To view running encoding configuration, type 'ENCODE R'.
To apply changes in configuration, type 'APPLY'.
Do not forget to 'CONFIRM' a good working configuration.
CO_01_CM>
4.6.5.5 <SECURE ON/OFF> Command
This command activates/deactivates the advanced security. The basic security allows 2 users,
ADMIN and USER. The Advanced Security software license allows up to eight users. Each user
can have different access rights to command line interface (CLI) and SNMP commands. The
optional access control list (ACL) is possible to set for every user additionally. The user will be
able to access the WEB interface and the CLI only if source IP address belongs to the defined
domain.
Starting from the software version 1.5.1, the Advanced Security option activates SSH and Radius
protocol support.
Note:
The SECURE ON feature needs a special LICENSE KEY that has to be ordered
together with the unit.
Starting from the software version 1.5.2 no additional LICENSE KEY is required for
activation of Advanced Security feature.
4.6.5.6 <USERS> Command
This command shows the list of users of the device with their control and access rights.
CO_CM>USERS
-----------------------------------------------------------------------------
Username Controls IP ACL
-----------------------------------------------------------------------------
ROOT ALL Local access only
WHEEL CONTROL,TEST,STATUS,CONFIG 192.168.1.64/30
NET C{SNMP,NET} 192.168.1.16/30
LAN S{LANC},C{LAN} 192.168.20.16/30
LINK CONTROL,TEST,S{LINKC},C{LINK} 192.168.20.24/30
WATCH S{LINK,LAN} Any IP
GUESTLINK S{LINKC},C{LINK} 192.168.2.16/30
-----------------------------------------------------------------------------
CO_CM>
4.6.5.7 <USER> Command
This command allows the control of various user parameters. You must have ADMIN rights to
use this command.
Command
Description
USER [username]
Creates a user USERNAME and asks for a password
USER [username] DEL
Deletes user USERNAME
USER [username] [+/-] [PRIV]
Modify privileges for user USERNAME