FlexDSL ORION 3 - TRAP [1;2] [V1;V2 C]> Command

User Manual LTU Orion 3
125
4.6.5.93 <TRAP [1/2] [V1/V2C]> Command
This command defines SNMP version of Trap messages for 1-s or 2-nd Trap receiver.
<TRAP 1 V1>. This command set SNMP version to v1 for 1-st Trap receiver.
<TRAP 2 V2C>. This command set SNMP version to V2c for 2-nd Trap receiver.
4.6.5.94 <TRAP [1/2] V3 [RO/RW]> Command
This command activates SNMP v3 for 1-st or 2-nd Trap receiver and assign the SNMP user (RO
or RW) from whom the Trap messages will be send.
<TRAP 1 V3 RO>. This command assign RO SNMP user as "author" of Trap messages headed
to 1-st Trap receiver.
<TRAP 2 V3 RW>. This command assign RW SNMP user as "author" of Trap messages headed
to 2-nd Trap receiver.
4.6.5.95 <COMMUNITY> Command
This command allows changing of SNMP community for SET/GET/TRAP messages.
COMMUNITY [GET/SET/TRAP] - set GET, SET or TRAP community.
COMMUNITY - set all 3 community strings to the same value.
4.6.5.96 <SNMPSET [ON/OFF]> Command
The <SNMPSET ON> command enables processing SNMP SET requests, which allow to
configure and manage the device, however, this command makes the device sensitive to attacks
over SNMP in unprotected PC networks.
The <SNMPSET OFF> command disables processing SNMP SET requests, what protects the
device from network attacks, but does not allow to configure and manage it.
Use this command to process SNMP SET requests only in protected networks. If the network is
not protected, use this command during configuration and administration only.
4.6.5.97 <SNMP [RO|RW] NAME> Command
This command set SNMPv3 user name for user with Read-Only (RO) or Read-Write (RW) access
rights.
<SNMP RO NAME>. This command set SNMP user with Read-Only access rights.
<SNMP RW NAME>. This command set SNMP user with Read-Write access rights.
4.6.5.98 <SNMP [RO|RW] AUTH [MODE]> Command
This command set SNMPv3 user authentication type for RO or RW user. The following
authentication types are supported: MD5,SHA,NONE.
<SNMP RO AUTH SHA>. This command set SHA authentication type for SNMP user with Read-
Only access rights.
<SNMP RW AUTH MD5>. This command set MD5 authentication type for SNMP user with Read-
Write access rights.
<SNMP RO AUTH NONE>. This command disables authentication for SNMP user with Read-
Only access rights.