FlexDSL ORION 3 - SOFTINFO> Command

User Manual LTU Orion 3
85
4.6.4.32 <SOFTINFO> Command
This command displays some information about the software, which are stored in the current
device. Any device can have two stored software copies (different versions are possible). One
copy of the software is started after switching power on, while the other is a backup software.
CP_01_FMM>SOFTINFO
*fpga : encryption 0.0.1, length: 142k, CRC OK
* key : v3, length: 1k, CRC OK
*cert : v3, length: 1k, CRC OK
1: ver.: 2.0.6, date: 24.8.2018, length: 771k, CRC OK, fixed
dsl : 1.7.5__001, length: 64k, CRC OK
2: * ver.: 2.0.6, date: 24.8.2018, length: 771k, CRC OK, confirmed
* dsl : 1.7.5__001, length: 64k, CRC OK
CP_01_FMM>
The asterisk shows actual firmware version that will start after next boot of the unit, FPGA and
DSL version and downloaded certificates and keys.
ver – The number of the software version.
date – The date of the software creation.
length – The size in bytes.
CRC OK/FAIL – A label showing if the software is damaged or not.
The software status is displayed at the end of the corresponding line:
fixed – First basic software. Cannot be downloaded, does not require confirmation.
just loaded – Downloaded second software.
not confirmed – Non-confirmed second software.
confirmed – Confirmed second software.
4.6.4.33 <PING x.x.x.x> Command
This command will PING any remote IP address. It sends an ICMP ECHO request message and
wait for the corresponding ICMP ECHO reply message. This command will not ping the own
device IP adress.
CO_FMM>PING 192.168.1.11
4.6.4.34 <MODEMVIEW> Command
This is a single command that collects and displays the modem configuration and status in a
readable format. It is helpful to get an overview of the modem with just one command.
4.6.4.35 <SD SNAPSHOT> Command
This command generates the SNAPSHOT DAT, APP.BIN, LDR_xTU.BIN and STARTUP.CFG
files in the O3MF directory on the SD card. This cmd is only available if the SD card is inserted.
4.6.4.36 <SD DIR> Command
This command shows the content of the SD card. This cmd is only available if the SD card is
inserted.
4.6.4.37 <SD DEL [NAME]> Command
This command allows to delete files from the SD card. This cmd is only available if the SD card
is inserted.
Example:
CO_01_FMM>SD DEL /O3MF/APP.BIN
CO_01_FMM>