CX_06_NET>H
-------------------------------------------------------------------------------
Type 'H [command]' to get additional help on [command]
NETCONFIG Show network configuration
NETCONFIG [N/R/S/B] Show new/running/startup/backup network configuration
COSCONFIG Show CoS configuration
COSCONFIG [N/R/S/B] Show new/running/startup/backup CoS configuration
RSTP DEFAULT Set default RSTP configuration
RSTP [CONF/STATE/DIAG] Show RSTP state/configuration/diagnostics
RSTP [BR/IF] [OPT] [N] Set RSTP Bridge/Interface properties
RSTP [A..E] [ON/OFF] Switch RSTP ON/OFF at PBVLAN A..E
PBVLAN [IF] [A..E/S] Set port-based VLAN for the interface
MODE [IF] [ACC/TRUNK/MIX]Set mode of LANx interfaces: access, trunk, mixed
VLAN [IF] [1..8] Set default VLAN index for access ports
QOS [IF] [0..7] Set default QoS for access ports
ALLOW [IF] [VLAN list] Set list of VLANS to allow on trunk interface
VID [1-8] ID Assign VID to the VLAN specified
MACLIST SHOW Show MAC filter settings
MACLIST SHOW [N/R/S/B] Show new/running/startup/backup MAC list
MACLIST [IF] ADD [MAC] Add MAC to the white list
MACLIST [IF] DEL [MAC/N] Delete MAC from the white list
MACFILTER [LAN1-5] [ON/OFF]Enable/disable MAC filtering
MACRULE [LAN1-5] [rule] Set the MAC Filter behaviour
SETIP x.x.x.x Set modem IP address
GATEWAY x.x.x.x Set gateway IP address
NETMASK x.x.x.x Set netmask
MTU [68..1500] Set port INT MTU
WANIDLE [1/7E] Select WAN idle pattern
ETHSD [MODE] [N=1-5] Set Nth Ethernet port speed
FC [ON/OFF] [N=1-5] Set Ethernet port flow control
To Next Page
Loading...
