The content of the configuration management menu mainly depends on the operation mode of
the device. There are four possible modes of the device operation:
CO – All channels are in the Master mode, manual configuration.
CP – All channels are in the Slave mode, manual configuration.
CX – Some Channels are in Master, some channels are in Slave mode, manual configuration.
CA - Configuration of E1 and WAN streams is received from the SHDSL line, automatic config.
In the CA mode, it is impossible to configure the channel reservation, to arbitrarily assign E1
streams to DSL channels and to arbitrarily set clock sources. Nevertheless, this mode satisfies
90% of users, because it does not require many efforts to configure the device.
4.6.5.1 <H> Command
Type <H> and the monitor lists all available commands in the configuration management sub-
menu. If you type H [command] you will get additional help on [command].
CO_01_CM>H
-------------------------------------------------------------------------------
Type 'H [command]' to get additional help on [command]
ENCODE [NRSB] Show WAN encoding
ENCODE KEY [N] Enter Pre-shared Key for Encoding
ENCODE [ON/OFF] [N] Enable/Disable encoding
SECURE [ON/OFF] Change security mode
USERS List user accounts
USER [name] Add user account
USER [name] DEL Delete user account
USER [name] [+|-] [PRIV] Assign user access rights
USER [name] [IP] [subnet]Set IP access list for user
USER [name] [LOCAL/ALL] Set all IP/ or local only user access
PASSWORD [user] Set user password
AUTO [ON/OFF] Set CA mode
CONFIG Display local configuration
CONFIG [N/R/S/B] Display new/running/startup/backup configuration
MASTER [ON/OFF] [N] Select Nth xDSL channel master/slave
EXT [ON/OFF] [N] Turn Nth DSL channel Extended mode ON or OFF
BASERATE [M/AUTO] [N] Set Nth DSL channel baserate to M*64k + 8k
PAM [4-128] [N] Set Nth xDSL channel line coding
PAYLOAD [list] [N] Set Nth xDSL channel payload
ANNEX [A,B,A/B] [N] Set Nth xDSL channel Annex A or Annex B or Annex A/B
SETCLOCK [list] [N] Set Nth xDSL channel clock source priorities
MULTIPAIR [2/3/4/2+2/OFF]Select or turn off multipair mode
RESERVE [list1] {list2} Set lists of channels for the reserve groups
G704 [ON/OFF] [N] Set Nth E1 framer G704 mode
CRC4 [ON/OFF] [N] Set Nth E1 framer CRC4 mode
AISDET [ON/OFF] [N] Set Nth E1 framer AIS detection mode
AISGEN [ON/OFF] [N] Set Nth E1 framer AIS generation mode
DSLTS [list] [N] Select Nth E1 channel timeslots, transmitted via DSL
WANTS [list] [N] Select Nth E1 channel timeslots for WAN payload
E1CLOCK {source} [N] Set Nth E1 channel clock source
E1MODE {mode} [N] Set Nth E1 channel coding or loop mode
POWER [ON/OFF] [N] Turn the remote power on/off over the N-th DSL channel
ID [string] Set/Clear device ID
RESPONSE [NN/OFF] Set response ID
DEFAULT [0-4] Set default configuration
DEFAULT EVERYTHING Set everything to default configuration
DEFAULT DESC Set default Description (ifAlias)
SERNUM Show serial number
GSCOMPAT [ON/OFF] Set GS compatibility mode on and off
NMTHR [N/OFF] Set Noise Margin alarm threshold
LATHR [N/OFF] Set Loop Attenuation alarm threshold
To Next Page
Loading...
