FlexDSL ORION 3 - STATUS RADIUS> Command

User Manual LTU Orion 3
74
4.6.4.7 <STATUS RADIUS> Command
The <STATUS RADIUS> command displays the actual status of RADIUS servers
CO_FMM>STATUS RADIUS
----------------------------------------------------------------------------
Status : Server 1 Server 2
----------------------------------------------------------------------------
Status : Connected Not connected
Server IP : 255.255.255.255 255.255.255.255
Server port : 1812 1812
Shared key : entered empty
Retries : 2
Timeout, seconds : 2
----------------------------------------------------------------------------
CO_FMM>
4.6.4.8 <STATUS DOT1X> Command
The <STATUS DOT1X> command shows IEEE 802.1x status per LAN interface.
CP_FMM>STATUS DOT1X
====================================
Port 802.1x mode Authorized
====================================
LAN1 Multi-host Yes
00:1b:24:a6:38:b6 Pass
08:00:27:c8:0c:b8 Auth
LAN2 Multi-host No
====================================
CP_FMM>
Parameter
Description
Authorized (Port)
Displays if LAN port received permission from server to pass traffic
Authorised (MAC)
Displays if device with MAC address either passed authentication (Auth),
or transmits traffic (Pass) or in blocking state (Block)
802.1x mode
Ether MAUTH, MHOST or SHOST
4.6.4.9 <STATUS ENCODE> Command
This command shows status of encoded WAN channel.
CO_01_FMM>STATUS ENCODE
--------------------------------------------------------------------------------
Destination : WAN1 WAN2 WAN3 WAN4
--------------------------------------------------------------------------------
Status : DSL1 DSL2 DSL3 DSL4
Enabled : no no no no
Remote :
Key :
--------------------------------------------------------------------------------
CO_01_FMM>
Parameter
Value
Description
Status
Connected
Not connected
Client has a connection with RADIUS server
Radius server is not configured or not responding
Server IP
IP Address
IP address of RADIUS Server
Server port
0-65535
UDP Port, the RADIUS server is listen on for incoming
connections
Shared key
Entered
Empty
Shared key is present in the client
Shared key is not present in the client
Retries
0-10
Number of retries, the client will use to authenticate the user
on both RADIUS servers. 0 means no attempts.
Timeout, seconds
1-5
Time interval between authentication attempts.