FlexDSL ORION 3 - Fault and Maintenance Management Menu

User Manual LTU Orion 3
71
4.6.4 Fault and Maintenance Management Menu
After typing “2” in the main menu and pressing <enter>, the following message is displayed:
Fault and maintenance management activated
Enter 'M' to return to MAIN, or 'H' for HELP information
CO_01_PM>
4.6.4.1 <H> Command
Type <H> and the monitor lists all available commands in the fault and maintenance sub-menu.
If you type H [command] you will get additional help on [command].
CX_06_FMM>H
-------------------------------------------------------------------------------
Type 'H [command]' to get additional help on [command]
NM Trace xDSL noise margin
LINKNM Trace xDSL noise margin of all accessible units
LINKALARM Display link alarms of all xDSL channels
ALARMLOG [N] Display the link alarm log
ALARMLOG C Clear the link alarm log
LINKDIAG Trace xDSL status of all accessible units
STATUS Show current DSL working parameters
STATUS T Show current DSL working parameters continuously
STATUS L Show current DSL and LINK payload parameters
STATUS ETH Show Ethernet status
STATUS LLDP Show LLDP neighbours
STATUS ENCODE Display current encryption status
STATUS RADIUS [NRSB] Show RADIUS server status and parameters
LOOP1 [ON/OFF] [N] Start/stop local loopback at Nth E1 interface
LOOP2 [N:[A/R]] [ON/OFF] Starts/stops the remote loopback at Nth xDSL interface
ALARM Display alarms
ALARM T Display alarms continuously
ACO Show alarm cutoff configuration
ACO [GROUP] [ON/OFF] Change alarm indication for alarm group GROUP
MACTABLE C Clear MAC table
MACTABLE [1-8/OTHER/Port]Print MAC table for VLAN/port
MACTABLE Print all MAC table entries
LLDP STAT [IF/ALL] Show LLDP status per port/for all ports
STARTAL [N] Toggles Nth xDSL channel the analog loopback ON/OFF
RESTART [N] Restart Nth xDSL channel
RESET Reset modem
CONFIRM Confirm running configuration
BACKUP Backup running configuration
RESTORE Restore startup configuration from backup
DIFF [N/R/S/B] [N/R/S/B] Show difference between configurations
DUMP [N/R/S/B] Dump selected configuration
LOAD Load configuration via XModem
TLM Show external alarm status
TLM D Show external alarm reaction
TLM S [N:Rnn-Rkk] [ABC] Set up external alarm reaction
TLM C Clear external alarm table
POWER DIAG Remote power diagnostics
LOG Show non-volatile log messages
LOG C Clear non-volatile log
SOFTUPDATE Update software
TFTP [CMD] [ARG1][ARG2] Perform maintenance over TFTP
SOFTCONFIRM Confirm uploaded software
SOFTINFO List loaded software
PING x.x.x.x PING host
LINKSTAT Display link status of all xDSL channels
RSTP [CONF/STATE] Show RSTP state/configuration
MODEMVIEW Collect modem configuration
SD BOOT [ON/OFF] Enable/Disable SD card boot mode
SD STATUS SD card status
BERT BERT configuration menu
APPLY [ALL/GROUP] Apply changes to running configuration
CONNECT [N:[1-13/R]] Establish connection to remote unit
LINK [NN] Establish local connection
LINKCLEAR Exit all local connections
M Return to Main Menu
H Show available commands