FlexDSL ORION 3 - STATUS ETH> Command

User Manual LTU Orion 3
73
Table 4.2 <STATUS> definitions
4.6.4.4 <STATUS ETH> Command
This command displays parameters of the Ethernet ports (ETH1 – ETH4), namely the rate and
the operation mode.
CO_01_FMM>STATUS ETH
Ethernet port 1 speed/duplex: ---
Ethernet port 2 speed/duplex: 100 FULL
Ethernet port 3 speed/duplex: ---
Ethernet port 4 speed/duplex: ---
CO_01_FMM>
4.6.4.5 <STATUS EXT> Command
This command displays status of daughter card or cards.
CP_FMM>STATUS EXT
------------------------------------------------
Card Cable RTS CTS DCD DTR DSR LL
------------------------------------------------
1. RS232 RS-232 OFF OFF OFF OFF OFF ---
------------------------------------------------
CP_FMM>
4.6.4.6 <STATUS LLDP> Command
The <STATUS LLDP> command shows LLDP neighbourhood.
CX_06_FMM>STATUS LLDP
MWAN1 neighbour:
Port description: MWAN2
Management address: 192.168.1.26
Chassis ID: 00:0f:d9:05:5e:61
Port ID: MWAN2
System description: FG-PAM-SA4N-2Eth, V84 LABOR (SW: 1.6.17 HW: 1.4)
CX_06_FMM>
Active sync. source
External
E1-1
E1-2
E1-3
E1-4
Internal
External sync
Е1-1 network interface
Е1-2 network interface
Е1-3 network interface
Е1-4 network interface
Internal sync source
Remote Power State
120V,ON
OFF
Remote Power Source switched on
Remote Power Source switched off
Temperature
N
Unit temperature [С]
Parameter
Value
Description
Port description
String
Remote port description
Management address
IP Address
IP address of remote unit
Chassis ID
ID
MAC address or ID of remote unit
Port ID
ID
Remote port identification
System description
String
Remote system description