4.6.4.43 <H> Command
Type <H> and the monitor lists all available commands in the BERT sub-menu. If you type H
[command] you will get additional help on [command].
CX_BERT>H
-------------------------------------------------------------------------------
Type 'H [command]' to get additional help on [command]
START Start BERT
STOP Stop BERT
TRACE Trace BERT statistics
SHOW Show BERT statistics once
RES Reset BERT statistics
SET [E11-E12] [INT/EXT] Set BERT interface
PATD [2En/bitstring] Set BERT pattern
TS [TX/RX] [list/NONE] Set controlled slot list
CONF Display current BERT configuration
APPLY [ALL/GROUP] Apply changes to running configuration
CONNECT [N:[1-13/R]] Establish connection to remote unit
LINK [NN] Establish local connection
LINKCLEAR Exit all local connections
M Return to Fault and Maintenance Menu
H Show available commands
To Next Page
Loading...
