FlexDSL ORION 3 - Commands

User Manual LTU Orion 3
62
4.6 Commands
4.6.1 Main Menu
The main menu is presented as shown below:
MODEL FG-PAM-SR4L-4E1B/4Eth-RP, V96
HW 1.6
SW 1.4.37 EXT rates
DATE 29-11-2012
ID
RUNS 0d 00:27:09
ALARM URGENT
STATUS LINK DOWN
MODEL_DESC Subrack Quad xDSL/Quad E1/Quad Ethernet 120 Ohm
IP 192.168.0.235
------------- Main Menu -----------------
1. Performance management (PM)
2. Fault and maintenance management (FMM)
3. Configuration management (CM)
5. Exit
-----------------------------------------
Select [1..5]
CP_01_MM>
To select the desired sub-menu, type the appropriate number from “1” to “5” and press <enter>.
4.6.1.1 System Invitation
The following format of the system invitation is used in all menus:
<cc>_<addr>_<sf>>
сс is the device mode:
• RR - Regenerator
• CO – Master
• CP – Slave
• CX – Modem with both types of modes (MASTER and SLAVE)
• CA – Device with automatic selection of the DSL line parameters (MASTER, BASERATE,
PAM and ANNEX)
addr is the address of:
• Regenerator in the system (only for Regenerators)
• LTU device in the subrack (slot number, only for subrack LTU devices)
sf is the short form of the current menu:
• MM – Main Menu
• PM – Performance Management
• FMM – Fault and Maintenance Management
• CM – Configuration Management).
For example: CO_PM>
means the device is in the Master mode and we are in the Performance Management menu.