FlexDSL ORION 3 - Radius Retries [0..10]

User Manual LTU Orion 3
133
--------------------------------------------------------------------------------
Running Network Configuration
<------------------------------------- cut ------------------------------------>
Service settings :
Running/Port : TELNET, SSH(2022), HTTP
Syslog servers : 255.255.255.255 255.255.255.255
SNTP servers : 255.255.255.255 255.255.255.255
RADIUS servers : 192.168.1.1:1812 255.255.255.255:1812
RADIUS secret : entered entered
--------------------------------------------------------------------------------
CO_04_NET>RADIUS 2 192.168.2.253:21812
--------------------------------------------------------------------------------
Running Network Configuration
<------------------------------------- cut ------------------------------------>
Service settings :
Running/Port : TELNET, SSH(2022), HTTP
Syslog servers : 255.255.255.255 255.255.255.255
SNTP servers : 255.255.255.255 255.255.255.255
RADIUS servers : 192.168.1.1:1812 192.168.1.2:21812
RADIUS secret : entered entered
--------------------------------------------------------------------------------
CO_04_NET>
4.6.5.116 <RADIUS RETRIES [0..10]>
Command defines the number of retries, the RADIUS client will try to authenticate at first and
second RADIUS server. If the first RADIUS server fail to give a reply within a defined timeout, the
client sends request to the second RADIUS server. The requests keep going until the number
exceeds the number of retries, then the client will use local record for authentication. Default
parameter is 2 retries.
CO_FMM>RADIUS RETRIES 5
----------------------------------------------------------------------------
Status : Server 1 Server 2
----------------------------------------------------------------------------
Status : Connected Not connected
Server IP : 255.255.255.255 255.255.255.255
Server port : 1812 1812
Shared key : entered empty
Retries : 5
Timeout, seconds : 2
----------------------------------------------------------------------------
CO_FMM>
4.6.5.117 <RADIUS TIMEOUT [1..5]>
Command defines the timeout is seconds. If RADIUS server gives no answer within defined
period, the RADIUS client initialises next attempt. Default parameter is 2 seconds.
CO_FMM>RADIUS TIMEOUT 3
----------------------------------------------------------------------------
Status : Server 1 Server 2
----------------------------------------------------------------------------
Status : Connected Not connected
Server IP : 255.255.255.255 255.255.255.255
Server port : 1812 1812
Shared key : entered empty
Retries : 5
Timeout, seconds : 3
----------------------------------------------------------------------------
CO_FMM>
4.6.5.118 <STATUS RADIUS [N/R/S/B]> Command
This command Show 1-st and 2-nd RADIUS server status and parameters.