FlexDSL ORION 3 - PASSWORD {Users}> Command

User Manual LTU Orion 3
93
The USER [USERNAME] [IP] [netclass] command is used to define the IP domain.
The USER [USERNAME] ALL command is used to allow access from all IP addresses.
The USER [USERNAME] LOCAL command is used to disable access from all IP addresses.
4.6.5.8 <PASSWORD {users}> Command
This command sets the access password for users. With basic security, there are two users
available: USER is a non-privileged, ADMIN is a privileged user. With advanced security, up to 8
users with arbitrary names are allowed.
PASSWORD ADMIN: sets password for the user ADMIN
PASSWORD USER: sets password for the user USER
CO_CM>PASSWORD USER
Enter password:
Confirm password:
Ok
Only the administrator can perform this command. The password length is not more than 11
symbols (advanced security 63 symbols). The password can contain Latin letters and digits.
Note:
It is also possible to set an empty password (in this case, the password is not requested
while opening the telnet session). This command sets the password only to access the
device over the telnet protocol. When managing the devices via the RS-232 interface,
the password is not requested.
4.6.5.9 <CONFIG N/R/S/B> Command
The <CONFIG> command always displays the running configuration of the device. If a new
configuration differs from the running one a warning is displayed. Options:
• N - Display New line configuration
• R - Display Running line configuration
• S - Display Startup line configuration
• B - Display Backup line configuration
CO_01_CM>CONFIG
--------------------------------------------------------------------------------
Running Line Configuration
--------------------------------------------------------------------------------
xDSL DSL1 DSL2 DSL3 DSL4
Mode : Master(HTU-C) Master(HTU-C) Master(HTU-C) Master(HTU-C)
Extended rates: OFF OFF OFF OFF
Line coding : PAM32 PAM32 PAM32 PAM32
Baserate : 89 89 89 89
Annex : B B B B
Payload : E1-1,WAN E1-2,WAN E1-3,WAN E1-4,WAN
Clock source : E1-1,Int E1-2,Int E1-3,Int E1-4,Int
Reserve : --- --- --- ---
Power : ON OFF OFF OFF
GS compatible : OFF
E1 E1-1 E1-2 E1-3 E1-4
G.704 framing : ON ON ON ON
CRC4 : ON ON ON ON
AIS Detection : ON ON ON ON
AIS Generation: ON ON ON ON
E1 clock : DSL DSL DSL DSL
TS into DSL : 0-31 0-31 0-31 0-31
TS into WAN : NONE NONE NONE NONE
--------------------------------------------------------------------------------
Group of SHDSL parameters
Mode
Master, Slave, Multipair
All slave, configured by master
All slave, MULTIPAIR xx, configured by master