FlexDSL ORION 3 - Page 91

User Manual LTU Orion 3
91
USER [username] [IP] [net]
Set the IP range for user USERNAME. Net should be in range
from 0 to 32. If no IP is set, no restrictions are applicable.
USER [username] LOCAL
Disable remote access for user USERNAME. This command is
equal to USER [username] 0.0.0.0 32.
USER [username] ALL
Allow access from any IP address for user USERNAME. This
command is equal to USER [username] 0.0.0.0 0.
Every user in the list has rights to control some parts of the device through the command line
interface. The list of control points is empty for the new user. To change (to add or to delete)
control points (Controls) the USER [USERNAME] [+|-] [PRIV] command is used. If “+” is selected,
the one of the following privileges will be added. In case if “-“ is used, the one of the following
privileges will be revoked.
All commands of the CLI are divided into 3 levels. Selection of upper level means that the
commands from low levels will be selected too. Some commands are available for every user,
they can’t be revoked.
Privileges
Hierarchy Levels
Description
Related commands
Top Level
Group
Subgroup
ALL
Commands of this
level are available
for everyone. No
additional
authorization is
required
ALARM
ALARM T
DISCONNECT
LINKCLEAR
TLM
SENSOR
ACO
SOFTINFO
CONTRO
L
[CTRL]
Operation of
remote devices
CONNECT
LINK
TEST
[T]
Test of the device
LOOP1
LOOP2
STARTAL
RESTART
PING
MACTABLE
MACTABLE C
BERT Submenu
ADMIN
[A]
Administration of
the device
DIFF
DUMP
SERNUM
LICENSE
ACO change
RESET
BACKUP
RESTORE
LOAD
TLM D
TLM S
TLM C
SENSOR [N]
[O/C]
TFTP
SOFTUPDATE
SOFTCONFIRM
ID
RESPONSE
PASSWORD
NMTHR
LATHR
LICENSE ADD
DEFAULT
EVERYTHING
SECURE
LOG
USERS
USER
APPLY
CONFIRM
STATUS
[S]
:LINK
Link status
G826
G826 C
G826 E1
G826 E1 C
ALLG826
LINKSTAT
LINKALARM
ALARMLOG
NM
LINKNM
STATUS
STATUS T
STATUS L
STATUS EXT
POWER DIAG
:LINKC
All commands from
LINK + reset of the
counters
RESETG826
RESETALLG826
ALARMLOG C
:LAN
Ethernet status
NETSTAT
NETERR
STATUS ETH
MACTABLE