FlexDSL ORION 3 - Page 146

User Manual LTU Orion 3
146
Subrack Unit: Enter in a subrack unit with the Monitor (LCT, RS-232) or Telnet interface.
Type following commands
Description
3 <>
Go to Configuration Management (CM)
<DEFAULT EVERYTHING> <>
Set everything to default configuration
<MASTER ON 1> <>
Configure SHDSL 1 as MASTER
<MASTER ON 2> <>
Configure SHDSL 2 as MASTER
<MASTER ON 3> <>
Configure SHDSL 3 as MASTER
<MASTER ON 4> <>
Configure SHDSL 4 as MASTER
<PAYLOAD WAN 1> <>
Configure Ethernet over SHDSL 1
<PAYLOAD WAN 2> <>
Configure Ethernet over SHDSL 2
<PAYLOAD WAN 3> <>
Configure Ethernet over SHDSL 3
<PAYLOAD WAN 4> <>
Configure Ethernet over SHDSL 4
<NET> <>
Go to NET menu
<SETIP 10.0.2.200> <>
Set the IP-address of the device
<NETMASK 255.0.0.0> <>
Set the subnet mask
<GATEWAY 10.0.0.101> <>
Set the default gateway
<M> <>
Go to Configuration Management (CM)
<M> <>
Go to Main Menu
2 <>
Go to Fault and maintenance management (FMM)
<APPLY ALL> <>
Apply all configurations (written in the running config.)
<CONFIRM> <>
Confirm all configurations (written in the startup config.)
In Menu Configuration Management (CM) you can type <CONFIG> to see the following picture:
CO_01_CM>CONFIG
--------------------------------------------------------------------------------
Running Line Configuration
--------------------------------------------------------------------------------
xDSL DSL1 DSL2 DSL3 DSL4
Mode : Master(HTU-C) Master(HTU-C) Master(HTU-C) Master(HTU-C)
Extended rates: OFF OFF OFF OFF
Line coding : PAM32 PAM32 PAM32 PAM32
Baserate : 89 89 89 89
Annex : B B B B
Payload : WAN WAN WAN WAN
Clock source : E1-1,Int E1-2,Int E1-3,Int E1-4,Int
Reserve : --- --- --- ---
Power : OFF OFF OFF OFF
GS compatible : OFF
E1 E1-1 E1-2 E1-3 E1-4
G.704 framing : ON ON ON ON
CRC4 : ON ON ON ON
AIS Detection : ON ON ON ON
AIS Generation: ON ON ON ON
E1 clock : DSL DSL DSL DSL
TS into DSL : 0-31 0-31 0-31 0-31
TS into WAN : NONE NONE NONE NONE
--------------------------------------------------------------------------------
CO_01_CM>