9-32 Section 9: Verifying the Model 9500B Accuracy Specification
Final Width = 215mm
Ver. Nominal Edge Output Lower Upper User's Lower Upper Measured 9500B
Pt. Rise/Fall Type Voltage Tolerance Tolerance Total Validity Validity Value Displayed
Time Limit Limit Measurement Tolerance Tolerance 'Rise Time'
(10% - 90%) (pk-pk) Uncertainty Limit Limit Value
†
EDG21 33.00mV -20ps +15ps ps ps ps ps
EDG22 66.00mV -20ps +15ps ps ps ps ps
EDG23 100.00mV -20ps +15ps ps ps ps ps
EDG24 200.00mV -20ps +15ps ps ps ps ps
EDG25 330.00mV -20ps +15ps ps ps ps ps
EDG26 660.00mV -20ps +15ps ps ps ps ps
EDG27 1.0V -20ps +15ps ps ps ps ps
EDG28 2.0V -20ps +15ps ps ps ps ps
EDG29 500mV -4ps +4ps ps ps ps ps
EDG30 500mV -4ps +4ps ps ps ps ps
∗∗: Verification points EDG21 to EDG28 available for Active Head Model 9560 only.
∗∗∗: Verification points EDG29 to EDG30 available for Active Head Model 9550 only.
Table 9.9.3.1 — Edge Function Verification Cont
Please copy the following table. Enter the calculation results and measurements in the appropriate columns on the copy:
70ps
25ps
***
70ps
70ps
70ps
**
**
**
**
To Next Page
