Fluke 9500B - Section 10 Calibrating the Model 9500 B; About Section 10; 9500 B Mainframe Calibration and Active Head Calibration; The Model 9500 B Calibration Mode

Section 10: Calibrating the Model 9500B: About Section 10 10.1-1
Final Width = 215mm
10.1 About Section 10
Section 10 Calibrating the Model 9500B
Section 10 outlines general procedures for calibrating the Model 9500B. In it you will find the recommended calibration methods,
details of the parameters that require calibration and the procedures needed to calibrate them.
This section is divided into the following sub-sections:
10.2 9500B Mainframe Calibration and Active Head™ Calibration
Functions and Methods.
10.3 The Model 9500B Calibration Mode
Selection of Calibration Mode, Special Calibration and Standard Calibration.
10.4 Standard Calibration — Basic Sequences
Using the Target Selection and Adjustment screens
10.5 Front-panel Calibration by Functions
General procedure, sequencing, equipment requirements, interconnections, procedures and
lists of calibration points for all functions requiring calibration.
10.6 Head Calibration Procedures
Calibrating sine, edge, timing markers, load capacitance and 50 Ω /1M Ω ratio functions.