Fluke 9500B - Page 44

3-18 Section 3: Model 9500B Controls: Modes of Operation Descriptions assume 9500B/1100
3.4.3.29 'CLEAR USER LIST'
Procedure Mode User List
A list of users is presented on the opening
menu screen of Procedure mode, where the
user's name can be selected to appear on the
certificate. New names can be added to the
screen at the same time.
Names cannot be removed from the list without
knowing the Config mode password, which
must be used to access the 'Clear user list'
facility.
1. For access to allow the Procedure mode
user list to be cleared, press the CLEAR
USER LIST screen key on the second
'Present Settings' screen. This transfers to
the confirmation screen:
TODAY'S DATE TIME
Configuration
C F BARNES
F J BLOGGS
J K FLIPFLOP
EXIT
Press OK to clear list
OK
3. OK removes all names from the list and
returns to the second 'Present Settings'
menu screen.
4. EXIT returns to the second 'Present
Settings' menu screen without removing
the names.
Sec 3.4.3.30 *IDN? CONFIG
Sec 3.4.3.31 `CAL Alarms`
To retain compatibility with software
applications that depend upon instrument
response to the IEEE 488.2 common command
*IDN? it may be necessary to configure your
“Fluke 9500B” to respond as a previous model
“9500” from a previous manufacturer E.g.
“Wavetek”.
1.
1.
On the second “Present Settings” menu
On the second “Present Settings” menu
screen, press the IDN screen key on the
screen, press the CAL Alarm key on the
bottom row of Softkeys. This transfers to
bottom row of Softkeys. This transfers to
the “*IDN? Config” screen:
the “CAL Alarm” screen:
2. The EXIT screen key reverts to the second
2. The EXIT screen key reverts to the second
“Present Settings” menu screen.
“Present Settings” menu screen.
TODAY'S DATE TIME
TODAY'S DATE TIME
Configuration
Configuration
The current *IDN? response is
The ‘Cal Due’ alarm state is
indicated by the highlight.
indicated by the highlight.
Use the softkeys to select
Use the softkeys to select
another.
another.
EXIT
EXIT
FLUKE
FLUKE
9500
9500
9500B
9500B
USE ALT
MANUF
ENABLE
TODAY'S DATE TIME
TODAY'S DATE TIME
Configuration
Configuration
Present Settings:
Present Settings:
Language English
Language English
Border line 7
Border line 7
Ø.
Ø.
ØØ
ØØ
Results card Disabled
Results card Disabled
Engineers Notes Disabled
Engineers Notes Disabled
Certificate Style 1
Certificate Style 1
EXIT
EXIT
SELECT
SELECT
LANG
LANG
RESULTS
RESULTS
CARD
CARD
ENG
ENG
NOTES
NOTES
CERT
CERT
DETAILS
DETAILS
CLEAR
CLEAR
USER
USER
LIST
LIST
BORDER
BORDER
LINE
LINE
Ser. No. XXXXXX Rev. XXX
Ser. No. XXXXXX Rev. XXX
Options : 3.2 GHz Hi acc xtal
Options : 3.2 GHz Hi acc xtal
*IDN?
*IDN?CAL
CAL
CONFIG
CONFIGALARM
ALARM
The default setting for calibration alarms is
enabled. This configuration allows these
alarms to be disabled.
Final Width = 215mm