98
22. JOB Management
22.1 Storage Media Select
For TS680 series, SD card slot is an standard equipment, user can record the measured
data in internal memory or SD card directly. Before your work, it is necessary select
appropriate storage media. For both memory, the file management procedures are same.
【Procedure of storage select】
1. Select [
MEM] in the status mode to enter into
memory management.
2. Select “
4. Storage Media Select” to enter
storage media setting screen.
3. Press F1:Internal MSD to set the internal card as
current storage media.
Or press F2:External SD to set the external SD card
as current storage media.
If the internal card is current storage media, will
display on screen right.
If the external SD card is current storage media,
will display on screen right.
NOTE
1. If the SD card is first using on the total station, when select it as storage media,
“Initialing” will take about 30s.
2. If there is no SD card in the card slot, if you select F2:External SD, <NO SD CARD>
Memory
1.JOB
2.Known data
3.Code
4.Storage Media Select
5.USB
Storage Media Slect
[F1:Internal MSD]
F2:External SD
Meas PC 0.0
ppm 0
SD
VA 302.5432gon II
HA 0.0000gon P3
EDM OCC OFST REC
Meas PC 0.0
ppm 0
SD
VA 302.5432gon II
HA 0.0000gon P3
EDM OCC OFST REC
To Next Page
Loading...
Need help?
General
