49
4. Aim at the next point P3 and press F1: [
MLM] to
begin measure. Repeat this operation to measure other
target points.
5. Press F2: [
MOVE], the last target measured
becomes the new starting position to perform MLM of
next target.
Press F4: [
MEAS] to re-measure the starting
position.
6. Press key {
ESC} back to menu mode.
Note:
◆ Once “S/%” is displayed, the distance between two points is displayed as the gradient
10.2 Change the Starting Point
The previous measured data could be set as the base point for the next operation.
【Procedure of changing the starting point】
1. Measure the start point P1 and the first target P2
following above steps 1, 2 and 3.
2. After measuring the two points, press F2: [MOVE],
and press F4: [
YES] to set the last measured point as
new starting point, or press F3: [
NO] to give up.
H2
H1
S2
S1 %1
%2
V2
V1
Start point (P1)
Point (P2)
Point (P3)
MLM
Move base point?
SD -0.001m
VA 368.3854gon
HA 243.4068gon
MNOS YES
MLM
S/% %
SD
HD
VD I
MLM MOVE MEAS
To Next Page
Loading...
Need help?
General
