17
3.7 How to Configure
Press key {★} on panel directly to enter into in any
status, and do some basic settings.
1. Backlight
Press numeric key {
1}, then press left key { } or
right key { } to turn on or not.
2. Laser pointer on/off
Press numeric key {
2}, then press left key { } or
right key { } to turn no/off laser beam for pointing
target.
3. LCD contrast
Press numeric key {
3}, then press left key { } or
right key { } to adjust LCD display contrast.
4. Reticle level
Press numeric key {
4}, then press left key { } or
right key { } to telescope illumination on reticle. If
the value is zero, the illumination is turned off.
5. Key beep
Press numeric key {5}, then press left key { } or
right key { } to turn on key beep or not, if you
select NO, you will not hear the beep voice when
press any key.
6. EDM setting menu
Press function key {F1} to open the EDM setting
menu.
Inst Config
1.Backlight : YES
2.Laser(OTS) :NO
3.LCD contrast :5
4.Reticle lev :7
5.Key Beep :YES
EDM
Inst Config
1.Backlight : YES
2.Laser(OTS) : YES
3.LCD contrast :5
4.Reticle lev :7
5.Key Beep :YES
EDM
Inst Config
1.Backlight : YES
2.Laser(OTS) : YES
3.LCD contrast :5
4.Reticle lev :7
5.Key Beep :YES
EDM
Inst Config
1.Backlight : YES
2.Laser(OTS) : YES
3.LCD contrast :5
4.Reticle lev :7
5.Key Beep :YES
EDM
EDM
Mode
Reflector
Prism const
Temp.
Pressure
ppm
0PPM
:Fine “r”
:Prism
:0
:20℃
:1013hPa
:0
Inst Config
1.Backlight : YES
2.Laser(OTS) :NO
3.LCD contrast :5
4.Reticle lev :7
5.Key Beep :YES
EDM
To Next Page
Loading...
