110
24. Code Management
You could edit codes in this mode. All existed codes in memory could be read for all jobs,
and the selected code could be recorded together with occupied data or measured data.
24.1 Edit Code list
【Procedure of inputting a code】
1. Select [
MEM] in the status mode to enter into
memory management.
2. Select “
3.Code” to enter into code management.
3. Select “1.Code Edit”, the code will display.
4. Press ▲ or ▼ key to move the cursor, and input or
correct code.
Here:
Press F1:[
↑↓.P] key to change the function of ▲
and ▼ keys, if it is light, press ▲ or▼ to move cursor
between adjacent codes. If it is back light, press▲ or
▼ key to move cursor to display adjacent pages.
Press F2:[TOP] key to move cursor to first code
Press F3:[LAST] key to move cursor to last code
Press F4:[DEL] key to selected code.
NOTE:
◆ The codes recorded in memory could be read for all JOBs.
◆ 50 codes can be inputted.
Memory
1.JOB
2.Known data
3.Code
4.Storage Media Select
5.USB
Code
1.Code Edit
2.Clear list
001:CODE
002:CODEA
003:CODEB
004:CODEBCD
005:CODEBDEG
006:CODEBES
007:
↑↓.P T O P LAST DEL
To Next Page
Loading...
