65
3. Aim at the target point and then press F1: [DIST].
You can press F4: [
I.HT] to re-input instrument height
or target height here.
4. Press F4: [
SET] to save the data, or press F3: [REC]
to record it in the list.
5. Press F3: [NO] back to the previous mode and press
F4: [
YES] to set the data.
15.2 Read Coordinate
Set the measured foresight point in the saved coordinates list as the occupied point, and
the previous occupied point becomes the back point.
1. Move the instrument to the measured forsight point.
2. Select “
2. Read coord”.
3. First aim the previous occupied point, then press F4:
[
YES] to set the previous foresight point coordinate as
the occupied point coordinate or press F3: [
NO] to
give up.
Save coord
VD 29.183ft
VA 315.3212gon
HA 64.5876gon
I
DIST I.HT
Save coord
VD 19.682ft
VA 159.9150gon
HA 68.0594gon
I
MEAS REC SET
Save coord
N 5.000
E 5.000
Z 29.877
> Set?
0NO0 YES
Traverse
1.Save coord
2.Read coord
Read coord
HA -0.0002gon
> Set?
0NO0 YES
To Next Page
Loading...
