Foif RTS680 Series User Manual

37
Press F1: [MEAS] to start distance measurement.
7. The difference of measured and stake out
value ”
S-O dSD” is displayed.
Move the prism forward and backward until “S-O
dSD” is 0m.
←: Move the prism left
→: Move the prism right
↓: Move the prism forward
↑: Move the prism backward
Press F4: [OK] back to stake out mode.
7.2 Coordinates Stake out Measurement
After setting coordinates for the point to be stake out, the instrument calculates the stake
out HA and HD. By selecting the HA and then the HD stake out functions, the required
coordinate location can be stake out.
To get the Z coordinate, attach the target to a pole etc, with the same target height.
【Procedure of coordinate stake out measurement】
1. Press F1: [
MENU] at P2 in the measure mode.
Select “
2. Stake out”.
2. Select “
1. Occ. Orientation”.
Input the occupied orientation data, see Ҥ6.1
Input the occupied point data ”.
Then set the azimuth angle of the backsight point,
see “§6.2 Azimuth setting”.
3. Select “
2. S-O data”, then select “3.Coord”.
S-O dSD↓ 5.251m
S-O dHA← 82.5440gon
SD
VD 149.3610gon
HA 334.9916gon I
MEAS MOKS
Point to be
stake out
Back sight
station
Instrument
station
Distanc
Angle
0
E
N
S-O
1. Occ. Orientation
2. S-O data
3. EDM
Menu P1
1.Coordinate
2.Stake out
3.Area
4.Offset
5.MLM
6.REM
7.Resection
Stake out
1.Height
2.Angle & Dist
3.Coord

Foif RTS680 Series Specifications

General

Brand	Foif
Model	RTS680 Series
Category	Measuring Instruments
Language	English