34
【Procedure of 3D coordinates measurement】
1. Aim at the target point.
2. Select “
2. Measure” to start. The coordinate value
of the target is displayed.
3. Press F2: [
TAGT] to re-input the occupied data if
necessary, see “§6.1 Input the occupied point data”.
You can press F4: [
REC] to record the data.
4. Aim at the next target, press F2: [
TAGT] to re-input
the target height if necessary, and press F1: [
MEAS] to
continue. Follow this operation till all targets have
been measured.
5. Press key {
ESC} back to the coordinate mode.
Coordinate
1. Occ. Orientation
2. Measure
3. EDM
4. JOB select
Coord Measure
N 1000.000
E 1000.000
Z 10.466
VA 132.3648gon II
HA 150.3536gon
MEAS TAGT REC
To Next Page
Loading...
