Foss Infratec 1241 - Page 5

Infratec™ 1241 Grain Analyzer
Service Manual 1001 5015 / Rev. 4
4.7.2 Software ...................................................................... 4:29
4.7.3 BIOS ............................................................................. 4:29
4.7.4 Monochromator Constants ........................................ 4:29
4.7.5 Operating Temperature ............................................. 4:29
4.7.6 Volume Information ................................................... 4:29
4.7.7 Voltage Information ................................................... 4:29
4.8 Clone Instrument .................................................... 4:29
4.9 Settings ..................................................................... 4:30
4.9.1 Default Settings .......................................................... 4:30
4.9.2 Scan Mode (Standard) ................................................ 4:30
4.10 Read Disk ................................................................... 4:30
4.11 Error Codes in Software Log (SL) and Hardware
Log (HL) ...................................................................... 4:31
4.11.1 Error 4, Grating Motor Error ...................................... 4:33
4.11.2 Error 22, MU/TWM Data Range Error ........................ 4:33
4.11.3 Error 32, Speckle Signal Blocked ................................ 4:33
4.11.4 Error 128, Path Length Error ...................................... 4:34
4.11.5 Error 512, Speckle Function Error .............................. 4:34
4.11.6 Error 16384, Strain Gauge Failure (Load Cell) ........... 4:34
4.11.7 Error 32768, Hardware Error ...................................... 4:34
4.11.8 Error 33292, Reference Scan too low ........................ 4:35
4.11.9 Error 33293, Too few valid Sub samples collected ... 4:35
4.11.10 Error 33294, Monochromator Shutter not able
to move ....................................................................... 4:35
4.12 Hardware Error Log (xxxxxxxx.HL) ..................... 4:36
4.12.1 Error Word .................................................................. 4:36
4.12.2 Commands .................................................................. 4:37
4.12.3 Status Word 1 ............................................................. 4:41
4.12.4 Status Word 2 ............................................................. 4:42
4.12.5 Error Word 1 ............................................................... 4:43
4.12.6 Error Word 2 ............................................................... 4:44
4.12.7 Error Word 3 ............................................................... 4:45
4.12.8 Error Word 4 bit encoding (0x0108) .......................... 4:45
4.12.9 DSP Version ................................................................. 4:45
4.13 Export Logs and Configuration ........................... 4:46
5 Service and Maintenance .......................... 5:1
5.1 Special Tools ............................................................... 5:1
5.2 Service Procedures .................................................... 5:1
5.2.1 Replacement of Display Kit .......................................... 5:1
5.2.2 Replacement of Keyboard Overlay .............................. 5:7
5.2.3 Replacement of Detector Unit Complete .................... 5:8