Special functions
47
7.5 Moistening and sealing letters
(optional)
Operating the optimail 30 with the specially available sealer lets you seal and meter
letters in a single step.
The sealer is filled with tap water and installed on the left side of the optimail 30. Two
catches fasten the sealer to the postage meter housing. For further information on
how to set up the sealer please refer to the Installation Guide.
The sealer is suitable for all commercially available gummed envelopes whose flaps
are not longer than 3" (78 mm).
The present chapter explains how to use the
sealer. Please refer to Chapters 4 and 5 on
how to set the meter imprint and to meter.
Moistening the envelope flap
• Hold the letter with the open flap facing
down.
• Engage the letter at the sealer in arrow
direction.
The illustration shows the correct letter posi-
tion in the sealer:
– the flap is beneath the stop
– the stop edge is exactly in the flap groove.
Stop edge
Stop
To Next Page
Loading...
