111
EN
Settings
General remarks
NOTE!
As a result of firmware updates, you may find that there are functions available on
your unit that are not described in these operating instructions or vice versa.
Certain illustrations may also differ slightly from the actual control elements on your device.
However, these controls function in exactly the same way.
WARNING!
Operating the equipment incorrectly can cause serious injury and damage.
► Do not use the functions described until you have thoroughly read and understood
these operating instructions
► Do not use the functions described until you have thoroughly read and understood all
the operating instructions for the system components, especially the safety rules
Overview The settings contain the following options:
Under "View"
- Units
- Standards
- UIBS (display brightness)
- DRSL (display replaced characteristics)
- Setting F1 and F2 special function parameters
- Setting the parameters for the Favourites button
- System data
Under "System"
- Interior lighting setup
- Restore factory settings
- Resetting the password for the power source website
- Information
- Special display for JobMaster
- Spot welding mode
Setting the units Select Setup menu / Settings / View / Unit
Press the right adjusting dial
The first of the available units is displayed.
Select the desired unit by turning the right adjusting dial:
- metric (mm, kg, etc.)
- imperial (in., lbs., etc.)
Press the right adjusting dial to apply the units
To exit the Setup menu, press the "Welding process" and "Mode" buttons at the same
time
1
2
3
4
5
To Next Page
Loading...
Need help?
General
