Fronius TPS 270i C User Manual

69
EN
MIG/MAG and CMT welding
Safety
WARNING!
Danger from incorrect operation.
Possible serious injury and damage to property.
► Do not use the functions described here until you have read and completely under-
stood these Operating Instructions.
► Do not use the functions described here until you have fully read and understood all of
the Operating Instructions for the system components, in particular the safety rules!
WARNING!
An electric shock can be fatal.
If the power source is connected to the mains electricity supply during installation, there is
a high risk of very serious injury and damage.
► Before carrying out any work on the device make sure that the power source mains
switch is in the "O" position
► Before carrying out any work on the device make sure that the power source is un-
plugged from the mains
MIG/MAG and
CMT welding –
overview
The "MIG/MAG and CMT welding" section comprises the following steps:
- Switching on the power source
- Selecting the welding process and operating mode
- Retrieving the currently set filler metal
- Selecting the filler metal
- Setting the welding parameters
- Setting the shielding gas flow rate
- MIG/MAG or CMT welding
Switching on the
power source
Connect the mains cable
Move the mains switch to the "I" position
IMPORTANT! For optimum welding results, the manufacturer recommends performing an
R/L alignment when starting the device for the first time and when any changes are made
to the welding system.
Setting the weld-
ing process and
operating mode
Press the "Welding process" button until the LED for the desired welding process
lights up
Press the "Mode" button until the LED for the desired operating mode lights up
1
2
1
2
1
2

Fronius TPS 270i C Specifications

General

Brand	Fronius
Model	TPS 270i C
Category	Welding System
Language	English