35
EN
Control panel
General Welding parameters can be easily changed and selected using the adjusting dial.
The parameters are shown on the display while welding is in progress.
The synergic function ensures that other welding parameters are also adjusted whenever
an individual parameter is changed.
NOTE!
As a result of firmware updates, you may find that your device has certain functions
that are not described in these operating instructions, or vice versa.
Certain illustrations may also differ slightly from the actual controls on your device, but
these controls function in exactly the same way.
Safety
WARNING!
Danger from incorrect operation.
Possible serious injury and damage to property.
► Do not use the functions described here until you have read and completely under-
stood these Operating Instructions.
► Do not use the functions described here until you have fully read and understood all of
the Operating Instructions for the system components, in particular the safety rules!
Control panel
(1) (2) (3) (4) (5) (6)
(7)
(10)
(8)
(9)
(17)
(16)
(15)
(14)
(13)
(12)
(11)
To Next Page
Loading...
Need help?
General
