50
Before installation and commissioning
Safety
WARNING!
Danger from incorrect operation.
Possible serious injury and damage to property.
► Do not use the functions described here until you have read and completely under-
stood these Operating Instructions.
► Do not use the functions described here until you have fully read and understood all of
the Operating Instructions for the system components, in particular the safety rules!
Proper use The power source may only be used for MIG/MAG, MMA and TIG welding. Any use above
and beyond this purpose is deemed improper. The manufacturer shall not be held liable for
any damage arising from such usage.
Proper use also includes:
- following all the information in the operating instructions
- carrying out all the specified inspection and servicing work
Setup regulations The device is tested to IP 23 protection, meaning:
- protection against penetration by solid foreign bodies with diameters > 12.5 mm (0.49
in.)
- protection against direct sprays of water at any angle up to 60° from the vertical
The device can be set up and operated outdoors in accordance with IP23. Avoid direct wet-
ting (e.g. from rain).
WARNING!
If one of these devices topples over or falls it could cause serious or even fatal inju-
ry.
► Place devices, upright consoles and trolleys on a solid, level surface in such a way that
they remain stable.
The venting duct is a very important safety feature. When choosing the installation location,
ensure that the cooling air can enter and exit unhindered through the air ducts on the front
and back of the device. Any electroconductive metallic dust (e.g. from grinding work) must
not be allowed to get sucked into the device.
Mains connection - The devices are designed for the mains voltage specified on the rating plate.
- Devices with a nominal voltage of 3 x 575 V must be operated on three-phase systems
with earthed star point.
- If your version of the appliance does not come with mains cables and mains plugs
ready-fitted, these must be fitted by a qualified person in accordance with national
standards.
- The fuse protection for the mains lead is indicated in the technical data.
To Next Page
Loading...
Need help?
General
