Fronius TPS 270i C User Manual

112
Setting the stand-
ards
Select Setup menu / Settings / View / Standard
Press the right adjusting dial
The first of the available standards is displayed.
Select the desired standard by turning the right adjusting dial:
- CEN
Name of filler metal according to European standards
(e.g. AlMg 5, CuSi3, Steel, etc.)
- AWS
Name of filler metal according to the American Welding Society Standard
(e.g. ER 5356, ER CuSi-A, ER 70 S-6, etc.)
Press the right adjusting dial to set the standard
To exit the Setup menu, press the "Welding process" and "Mode" buttons at the same
time
Setting the dis-
play brightness
Select Setup menu / Settings / View / UIBS
UIBS = User interface brightness settings
Press the right adjusting dial
The value for the display brightness is shown.
Select the desired display brightness by turning the right adjusting dial (1 - 4)
Press the right adjusting dial to apply the value
To exit the Setup menu, press the "Welding process" and "Mode" buttons at the same
time
Displaying re-
placed character-
istics
Select setup menu / Settings / View / DRSL
DRSL = Display replaced synergic lines
Press the right adjusting dial
Select "on" by turning the right adjusting dial
Press the right adjusting dial to activate the function
To exit the Setup menu, press the "Welding process" and "Mode" buttons at the same
time
Setting F1 and F2
special function
parameters via
the Setup menu
Select Setup menu / Settings / View / F1/F2 Param.
Press the right adjusting dial
The parameters currently stored under F1 and F2 are displayed.
If no parameters are stored, the first possible parameter is displayed.
Select the desired parameter by turning the right adjusting dial
Press the right adjusting dial
1
2
3
4
5
1
2
3
4
5
1
2
3
4
5
1
2
3
4

Fronius TPS 270i C Specifications

General

Brand	Fronius
Model	TPS 270i C
Category	Welding System
Language	English