Fronius TPS 270i C - Welding Parameters for MIG;MAG Standard Synergic Welding and LSC Welding

75
EN
using the right adjusting dial:
Arc length correction
for correcting the arc length;
Setting range: -10 - +10
Factory setting: 0
- .... shorter arc length
0 ... neutral arc length
+ ... longer arc length
Welding voltage
1)
in V
Setting range: depends on the welding process and welding program selected
Before the start of welding, the machine automatically displays a standard value based on
the programmed parameters. The actual value is displayed during welding.
Pulse/dynamic correction
for correcting the pulsing energy of a pulsed arc
Setting range: -10 - +10
Factory setting: 0
- ... lower droplet detachment force
0 ... neutral droplet detachment force
+ ... increased droplet detachment force
Special function
any parameter can be assigned to this (see page 41)
The function can be selected if a parameter has been saved.
Welding parame-
ters for MIG/MAG
standard syner-
gic welding and
LSC welding
The following welding parameters can be set and displayed for MIG/MAG standard syner-
gic welding and LSC welding:
using the left adjusting dial:
Material thickness
1)
Setting range: 0.1 - 30.0 mm
2)
/ 0.004 - 1.18 in.
2)