88
Welding parame-
ters for manual
metal arc welding
The following welding parameters can be set and displayed for manual metal arc welding:
using the left adjusting dial:
Main current
1)
in A
Setting range: depends on the power source available
Before the start of welding, the machine automatically displays a standard value based on
the programmed parameters. The actual value is displayed during welding.
using the right adjusting dial:
Arc-force dynamic
to influence the short-circuiting dynamic at the instant of droplet transfer
Setting range: 0 - 100
Factory setting: 20
0 ... soft and low-spatter arc
100 ... harder and more stable arc
To Next Page
Loading...
Need help?
General
