87
EN
IMPORTANT! For optimum welding results, the manufacturer recommends performing an
R/L alignment when starting the device for the first time and when any changes are made
to the welding system.
Press the "Welding process" button until the LED for the STICK/TIG welding process
lights up and "STICK" is shown on the display.
After a short time, the currently set welding current and the currently set dynamic are
shown on the display. The welding current and dynamic indicators light up.
The welding voltage is applied to the welding socket with a three second time lag.
NOTE!
Parameters that have been set on a system component control panel (e.g. wire feed
unit or remote control) might not be able to be changed on the power source control
panel.
To change the welding current, turn the left adjusting dial
If required, turn the right adjusting dial to change the dynamic
The amended values are applied immediately.
Adjust the process parameters accordingly to make user- or application-specific set-
tings on the welding system
Start welding
STICK
2
2
3
4
5
6
To Next Page
Loading...
Need help?
General
