41
EN
F1/F2 special function parameters, Favourites but-
ton
F1 and F2 special
function parame-
ters
Setting F1 and F2 special function parameters
Example: the selected parameter I-S is assigned to F1
Select the desired parameter in the Setup menu
Further information on the Setup menu can be found from page 89
To assign the selected parameter to F1 or F2, press the parameter selection button
for approx. 3 seconds:
F1 ... left parameter selection
F2 ... right parameter selection
F1/F2 flashes while the parameter selection button is pressed.
As soon as the parameter is saved, the indicator for the corresponding special function pa-
rameter lights up.
F1 (for example) and a tick is shown next to the parameter:
The selected parameter is now stored under F1.
If a parameter cannot be assigned to the F1 or F2 special function parameters, after ap-
prox. 5 seconds F1 (for example) and X is displayed:
This deletes an existing stored parameter.
Retrieving F1 and F2 special function parameters
I-S [%] 150
~ 3 sec.
2
2
~ 3 sec.
1
1
2
To Next Page
Loading...
Need help?
General
