115
EN
Restoring the fac-
tory settings
Select Setup menu / Settings / System / FAC
Press the right adjusting dial
Turn the right adjusting dial to select "Yes", thereby restoring the power source to the
factory settings
Press the right adjusting dial
The process parameters and machine default values are immediately reset to the factory
settings without any further warning.
To exit the Setup menu, press the "Welding process" and "Mode" buttons at the same
time
Resetting the
password for the
power source
website
Select Setup menu / Settings / System / Web-PWreset
Press the right adjusting dial
Turn the right adjusting dial to select "Yes", thereby resetting the password for the
power source:
User name = admin
Password = admin
Press the right adjusting dial
The password is immediately reset to the factory settings without any further warning.
To exit the Setup menu, press the "Welding process" and "Mode" buttons at the same
time
Retrieving device
information
Select Setup menu / Settings / System / Information
Press the right adjusting dial
The first item of available information is displayed.
Select the desired information by turning the right adjusting dial
Serial number
Image version
IP address
MAC address
Press the right adjusting dial to display the information
To exit the Setup menu, press the "Welding process" and "Mode" buttons at the same
time
Setting the spe-
cial display for
JobMaster
Select Setup menu / Settings / System / iJob
Press the right adjusting dial
Activate or deactivate the function by turning the right adjusting dial:
off ... the special display for JobMaster is deactivated
on ... the special display for JobMaster is activated
Press the right adjusting dial
To exit the Setup menu, press the "Welding process" and "Mode" buttons at the same
time
1
2
3
4
5
1
2
3
4
5
1
2
3
4
5
1
2
3
4
5