Fronius TPS 270i C - Welding Parameters for Specific Processes

74
MIG/MAG and CMT welding parameters
Welding parame-
ters for MIG/MAG
pulse synergic
welding, for CMT
welding and PMC
welding
The following welding parameters can be set and displayed for MIG/MAG pulse synergic
welding, CMT welding and PMC welding:
using the left adjusting dial:
Material thickness
1)
Setting range: 0.1 - 30.0 mm
2)
/ 0.004 - 1.18 in.
2)
Welding current
1)
in A
Setting range: depends on the welding process and welding program selected
Before the start of welding, the machine automatically displays a standard value based on
the programmed parameters. The actual value is displayed during welding.
Wire speed
1)
Setting range: 0.5 - 25 m/min
2)
/ 20 - 980 ipm.
2)
Special function
any parameter can be assigned to this (see page 41)
The function can be selected if a parameter has been saved.
Penetration stabilizer
4)
(see page 95)
Setting range: 0 - 10 m/min / 0 - 393.7 ipm
Factory setting: 0
Arc length stabilizer
4)
(see page 97)
Setting range: 0 - 5
Factory setting: 0