Fronius TPS 270i C User Manual

27
EN
galvannealed
PMC
Characteristics for iron/zinc-coated sheet surfaces
gap-bridging
CMT, PMC
Characteristics with very low heat input for optimum gap-bridging ability
Hot spot
CMT
Characteristics with hot start sequence, specially for plug welds and MIG/MAG spot weld
joints
mix **
PMC
Also required: Pulse and PMC welding packages
Characteristics with process switch between pulsed and dip transfer arc
Specially for welding vertical-up seams with cyclic change between a hot and cold support-
ing process phase.
mix **
/
***
CMT
Also required: CMT drive unit WF 60i Robacta Drive CMT, Pulse, Standard and CMT weld-
ing packages
Characteristics with process switch between pulsed and CMT, where the CMT process is
initiated by wire movement reversal.
mix drive ***
PMC
Also required: PushPull drive unit WF 25i Robacta Drive or WF 60i Robacta Drive CMT,
Pulse and PMC welding packages
Characteristics with process switch between pulsed and dip transfer arc, where the dip
transfer arc is initiated by wire movement reversal.
multi arc
PMC
Characteristics for components being welded by several arcs each influencing the other
PCS **
PMC
Pulse Controlled Spray Arc - Direct transition from the concentrated pulsed arc to a short
spray arc. The advantages of pulsed and standard arcs combined in a single characteristic
pipe
PMC
Characteristic for pipe applications and positional welding on narrow gap applications
retro
CMT, Pulse, PMC, Standard
Characteristics with the properties of the TransPuls Synergic (TPS) predecessor series

Fronius TPS 270i C Specifications

General

Brand	Fronius
Model	TPS 270i C
Category	Welding System
Language	English