Fronius TPS 270i C User Manual

94
AlE
End arc length correction
For correcting the arc length at the end of welding
Setting range: -10 - +10% (of welding voltage)
Factory setting: 0
- .... shorter arc length
0 ... neutral arc length
+ ... longer arc length
t-E
Final current time
For setting the length of time for which the final current is to be active
Setting range: off / 0.1 - 10.0 s
Factory setting: off
SFI
to activate/deactivate the SFI function (Spatter Free Ignition of the arc)
Setting range: off / on
Factory setting: off
SFI-HS
SFI HotStart
For setting a HotStart time in conjunction with SFI ignition
During SFI ignition, a spray arc phase occurs within the set HotStart time. This increases
the heat input irrespective of the mode, thus ensuring deeper penetration right from the
very start of welding.
Setting range: off / 0.01 - 2.00 s
Factory setting: off
W-r
Wire retract
For setting the wire withdrawal value (= composite value based on backward movement of
wire and a time).
The wire withdrawal depends on the features of the welding torch.
Setting range: 0.0 - 10.0
Factory setting: 0.0
IgC
Ignition current (manual mode)
For setting the ignition current for MIG/MAG standard manual welding
Setting range: 100 - 450 A
Factory setting: 450
W-r (man.)
Wire retract (manual mode)
For setting the wire withdrawal value (= composite value based on backward movement of
wire and a time) for MIG/MAG standard manual welding.
The wire withdrawal depends on the features of the welding torch.
Setting range: 0.0 - 10.0
Factory setting: 0.0

Fronius TPS 270i C Specifications

General

Brand	Fronius
Model	TPS 270i C
Category	Welding System
Language	English