Loading Paper
251
Paper and Other Media
9
2 Check the positions of the paper
guides of the Tray 5 (bypass).
Note • Normally adjust the paper
guides to [Standard].
When paper guides are set to
[12" (305 mm)] or [12.6" (320
mm)], set them back to
[Standard] position. When
printing or copying with paper
sizes that exceeds A3 (297
mm) such as 12 x 18 inches or
12.6 x 17.7 (SRA3) inches,
move the paper guides. For
information on how to move
paper guides, refer to "Moving
the Position of the Paper Guides" (P.252).
3 Load paper with the side to be
copied or printed on face down, and
insert the paper lightly along the
paper guides until it comes to a
stop.
Important • Do not load mixed paper types
into the tray.
• Do not load paper exceeding
the maximum fill line. It may
cause paper jams or machine
malfunctions.
• When making copies or
printing on thick-stock paper
such as postcards, and the
paper is not fed into the
machine, apply a curl to the
leading edge of the paper as
shown in the figure on the
right. Note, however, that
excessively bending or folder
the paper might cause paper
jams.
• Depending on the type of the
paper, paper may not be fed to the machine or image quality may deteriorate.
4 Adjust the paper guides to just
touch the edges of the paper
loaded.
5 Select a copy or print job.
To Next Page
Loading...
