Setup Menu
337
System Settings
10
1 Select [Off] or [On].
2 When [On] is selected, select
[Comment].
3 Select [Recipient's Comment].
4 Select [On], and select a comment
from the displayed list of
comments.
Note • Select [ ] to return to the
previous screen or [ ] to
move to the next screen.
5 Select [Save].
6 To insert a [Sender's Comment], repeat the procedure of Steps 4 and 5.
Maximum Image Size
Select the maximum storage size from [A3], [B4], and [A4], to match the recipient's paper size
or processable profile.
Delayed Start
Set whether or not to use a delayed start transmission.
If the machine’s system clock is set to the 24-hour display, [AM] and [PM] do not appear. For
information on the system clock, refer to Time (P.272).
Remote Mailbox
Select whether to use mailbox communications. Note that when using mailbox
communications, the other party's mailbox number and password must be set in advance.
1 Select [Off] or [On].
2 If you selected [On], enter a
recipient's mailbox number with the
numeric keypad, and select [Next].
3 If a passcode is set, enter the
passcode with the numeric keypad, and select [Save].
Note • If no password is set, do not input anything, and select [Save].
F Code
Select whether to use F code communications.
F Code is the transmission procedure set by the Communications and Information Network
Association of Japan and is the T.30 (communication protocol) method for using sub-
addresses that was standardized by the ITU-T.
The F code (sub address) and password use not more than 20 digits 0 to 9, ∗, and #.
To Next Page
Loading...
Need help?
General
