15 Problem Solving
480
Problem Solving
15
016-717
O [Cause] Unable to create a transmission report (undelivered) or
transmission report because transmission result
information required for creating the report is not stored in
the machine's memory.
[Remedy] Take one of the following actions:
z
Execute the jobs for large size iFax documents (about
2GB) by splitting each document to minimize memory or
HDD usage.
z
After the job that you want to check in a report is
completed, do not execute 200 or more jobs to have the
job recorded on a report.
016-718
O [Cause] Unable to process the PCL print data due to insufficient
memory.
[Remedy] Reduce the resolution, or cancel 2-sided printing or N up,
and then print again.
016-719
O [Cause] Unable to process the PCL print data due to insufficient
print page buffer.
[Remedy] Increase the size of the print page buffer.
016-720
O [Cause] An invalid command is included in PCL print data.
[Remedy] Check the print data and try to print again.
016-721
O O [Cause] An error occurred during print processing. Probable
causes are as follows:
1. Printing was instructed by [automatic tray selection]
when [Paper Type Priority] is set to [Automatic Tray
switching Off] for all paper in the [Common Settings].
2. ESC/P command error
[Remedy] For Cause 1: When printing by automatic tray selection,
set one of the paper types to a setting other than
[Automatic Tray switching Off] in [Paper Type Priority].
For Cause 2:Check the print data.
Refer to "Paper Type Priority" (P.278).
016-722
O [Cause] The specified staple position or the specified paper size is
not supported in the finisher.
[Remedy] Check the staple position and the paper size, and try to
print again.
016-723
O [Cause] The specified punch position or the specified paper size is
not supported in the finisher.
[Remedy] Check the punch position and the paper size, and try to
print again.
016-724
O [Cause] The specified staple and punch position combination is
unsupported.
[Remedy] Specify the staple and punch positions to be on the same
side, and try to print again.
016-725
O [Cause] A scanned document stored in a mailbox was to be sent by
fax using the Job Flow feature, but the mailbox document
could not be converted to fax data.
[Remedy] Do not use the Job Flow feature. Simply scan the
document through the machine's [Fax] screen to send it by
fax.
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
