Error Code
505
Problem Solving
15
027-796
O O O [Cause] The received e-mail was discarded because it had no
attached documents. (The machine is set to print attached
documents only.)
[Remedy] To also print the mail body or header information, change
settings in the Properties screen of CentreWare Internet
Services.
Refer to "E-mail Printing" (P.229).
027-797
O O [Cause] The output destination of the received e-mail is invalid.
[Remedy] Specify a correct output destination, and send the e-mail
again.
033-363
O [Cause] An error occurred during fax transmission.
[Remedy] Contact our Customer Support Center.
033-710
O [Cause] The document to be sent by polling was deleted.
[Remedy] Store the document again.
033-712
O [Cause] Unable to process due to insufficient memory.
[Remedy] Remove unnecessary data.
033-713
O [Cause] An error occurred during fax transmission.
[Remedy] Contact our Customer Support Center.
033-716
O [Cause] The mailbox specified from the sender's machine does not
exist.
[Remedy] Register the mailbox.
Refer to "Mailbox" (P.328).
033-717
O [Cause] The mailbox password specified from the sender's
machine is incorrect. Or, the machine password is
incorrect.
[Remedy] Notify the correct password to the sender's machine.
033-718
O [Cause] Fax or polling documents do not exist in the mailbox
specified from the sender's machine.
[Remedy] Store fax or polling documents into the mailbox as
necessary.
033-719
O [Cause] The document may be deleted by turning off and on the
machine.
[Remedy] Retry sending.
033-721
O [Cause] An error occurred during fax transmission.
[Remedy] Turn the machine off and on. If the machine conditions are
not improved by performing the relevant remedy, contact
our Customer Support Center.
033-722
O [Cause] The document is jammed, or the document pages are over
the limit.
[Remedy] Remove the jammed paper or reduce the document
pages, and retry sending.
033-724
O [Cause] The reception was interrupted because the image volume
exceeded the upper limit.
[Remedy] Attach a HDD or 256MB Memory to increase the maximum
volume of image data.
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
