15 Problem Solving
506
Problem Solving
15
033-725
O [Cause] The hard disk is full.
[Remedy] Remove unnecessary data from the hard disk to increase
free disk space.
033-726
O [Cause] The received document was printed with the single sided
printing, because the 2-sided printing is not available for a
mixed sized document.
[Remedy] No operation is necessary.
033-727
O [Cause] The received page was printed without being rotated,
because its data volume was too large to change the
orientation automatically.
[Remedy] No operation is necessary.
033-728
O [Cause] The Auto Print formatting of the received fax document
was interrupted by a manual print operation.
[Remedy] No operation is necessary. The machine will automatically
start the Auto Print job after manual printing.
033-730
O [Cause] An error occurred during fax transmission.
[Remedy]Turn the machine off and on. If the machine conditions are
not improved by performing the relevant remedy, contact
our Customer Support Center.
033-731
O [Cause] The print job for the received fax document was
interrupted.
[Remedy] The Auto Print processing of the received fax document
was interrupted by a manual print operation. No operation
is necessary.
033-733
O [Cause] An error occurred during fax transmission.
[Remedy] Turn the machine off and on. If the machine conditions are
not improved by performing the relevant remedy, contact
our Customer Support Center.
033-734
O [Cause] The print job of the received fax document was interrupted
by a report job.
[Remedy] No operation is necessary.
033-735
O [Cause] An error occurred during fax transmission.
[Remedy] Turn the machine off and on. If the machine conditions are
not improved by performing the relevant remedy, contact
our Customer Support Center.
033-736
O [Cause] The forwarding job was interrupted because the data
volume exceeded the upper limit.
[Remedy] No operation is necessary.
033-737
O [Cause] An error occurred during fax transmission.
[Remedy] Try again.
033-738
O [Cause] Received abnormal JBIG data.
[Remedy] No operation is necessary.
033-740
O [Cause] The print job for the received fax document was
interrupted.
[Remedy] No operation is necessary.
Error Code
Category
Cause and Remedy
CPFSMO
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
To Next Page
Loading...
Need help?
General
