Fuji Xerox DocuPrint CM505 da - Page 165

Connectivity & Network Setup
165
Tools
5
• You can configure the E-mail Notification Service in CentreWare Internet Services. For more
information, refer to the help of CentreWare Internet Services.
WSD
WSD Print - Port Status
Select [Enabled] to use UPnP.
Set this when you search a device on a network from Windows Vista and Windows 7.
Port Number
Enter a port number from 1 to 65535.
The default value is 80.
Important • If the default port number is used, it may conflict with other ports. Make sure to set up the
port number that is not in use.
Note • WSD stands for Web Services on Devices.
Internet Services (HTTP)
Port Status
Select [Enabled] to use CentreWare Internet Services.
For more information about CentreWare Internet Services, refer to "CentreWare Internet Services
Settings" (P.251).
Port Number
Enter a port number for the Internet Services from 1 to 65535.
The default value is 80.
Important • If the default port number is used, it may conflict with other ports. Make sure to set up the
port number that is not in use.
Note • You cannot select [Port Number], if HTTP port is disabled.
To configure [Port Number], enable port status and reboot the machine, and then configure
[Port Number].
SOAP
Port Status
Select [Enabled] when you use an application program such as EasyOperator.
Port Number
Enter a port number for SOAP from 1 to 65535.
The default value is 80.
Important • If the default port number is used, it may conflict with other ports. Make sure to set up the
port number that is not in use.
WebDAV
Port Status
Select [Enabled] when you use an application program such as EasyOperator and Network
Scanner Utility 3 to access folders in the machine.
Note • You cannot select [Port Number] and [Operation Time-Out], if WebDAV port is disabled.
To configure [Port Number] and [Operation Time-Out], enable port status and reboot the
machine, and then configure [Port Number] and [Operation Time-Out].
Port Number
Enter a port number for WebDAV from 1 to 65535.
The default value is 80.
Important • If the default port number is used, it may conflict with other ports. Make sure to set up the
port number that is not in use.
Operation Time-Out
You can enter a operation time-out period between 1 and 65535 seconds in 1 second
increments.